enameled copper wire stripping machine X-6007
I, the use of knife head debugging method (enameled wire thickness head adjustment method)
1, put the knife up to greater than the wire diameter, and then put the needs of the enameled wire into the edge of the central. The knife edge to adjust clamping enameled wire, enameled wire inside and outside the push and pull of injury to the enameled wire paint properly.
2, tightening the screw side note: do not immediately lock screws, to balance lock, so that the inside blade average, scraping paint effect is good.
3, the enameled wire is pulled out, press the power switch, the enameled wire can be inserted into the edge of the central, paint stripping.
II, performance and parameters
1, machine size: 270X170X130mm,
2 scratch line diameter: 0.3 - 6.0mm.
3, voltage: ~220V 100W,
4 operating modes: desktop, electric
5, paint scraping length: 3- 45mm (longer length can customize).
6 speed: stepless speed regulation
The machine capacity of about 600pcs/ hour, suitable for electronic manufacturers to enamel wire scraping paint work.
